Corrosion under pipe support inspection by advanced ultrasonic method
Corrosion under pipe support inspection by advanced ultrasonic method
Non-standard referencing in tube inspection causes confusion during repair (Plug tube)
"Clearly referencing the test side per international standards is essential for accurately locating inspected tubes and identifying those needing repair."
Varying Reference Gain in PAUT Set-up Files Impacts Indication Assessment
“Using a changed Set-up file (reference gain) affects the size of the surface indication and may cause confusion in equipment monitoring result.”
Lack of Signals in IRIS Inspection Due to Rough-Surfaced Tubes
Centering the IRIS probe and adjusting the software parameter setup are essential for improving signal quality in tubes with rough internal surfaces.
.jpg)
Advanced inspection technologies for jetty piles inspection
Synergistic Solutions for Jetty Piles Inspection Ensuring the integrity of critical infrastructure by UAV, ROV and PEC
PAUT for effectiveness measurement chloride stress corrosion cracking
The experiment directly contributes to enhanced Cl-SCC detection and sizing capabilities, ultimately improving asset integrity and reliability.
Stud Bolt Inspection by Advanced ultrasonic testing
On-Stream Inspection : Ultrasonic methods can often be applied without taking equipment offline and without the need to remove the stud bolt, minimizing disruptions to operations.
Thickness of low finned tube for IRIS inspection result analysis
Detail of engineering drawing of low finned tube is important for IRIS inspection and remaining life assessment.
PAUT corrosion mapping constraint at Pipe Tee
Corrosion mapping by PAUT HydroFORM probe at Pipe Tee (Pipe fitting) may not covered 100% area of interest.
Anomalous eddy current signal from foreign material deposit
Foreign material inside the tube affecting heat exchanger tube inspection (ECT)
